Filter
Top Products
Routing Commands
249
ProSafe Managed Switch
release dhcp
Use this command to force the DHCPv4 client to release the leased address from the
specified interface.
Format release dhcp <unit/slot/port>
Mode
renew dhcp
Use this command to force the DHCPv4 client to immediately renew an IPv4 address lease
on the specified interface.
Format renew dhcp {<unit/slot/port>|network-port}
Mode
Note: This command can be used on in-band ports as well as network
(out-of-band) port.
show dhcp lease
Use this command to display a list of IPv4 addresses currently leased from a DHCP server
on a specific in-band interface or all in-band interfaces. This command does not apply to
service or network ports.
Format show dhcp lease [interface <unit/slot/port>]
Mode
IP address,
Subnet mask
DHCP Lease
server
State
DHCP transaction
ID
Lease
Renewal
Rebind
Retry count
Privileged EXEC
Privileged EXEC
Privileged EXEC
Term Definition
The IP address and network mask leased from the DHCP server.
The IPv4 address of the DHCP server that leased the address.
State of the DHCPv4 Client on this interface.
The transaction ID of the DHCPv4 Client.
The time (in seconds) that the IP address was leased by the server.
The time (in seconds) when the next DHCP renew Request is sent by DHCPv4 Client
to renew the leased IP address.
The time (in seconds) when the DHCP Rebind process starts.
Number of times the DHCPv4 client sends a DHCP REQUEST message before the
server responds.