Filter
Top Products
Switching Commands
179
ProSafe Managed Switch
no set igmp querier version
Use this command to set the IGMP Querier version to its default value.
Format no set igmp querier version
Mode
set igmp querier election participate
Use this command to enable the Snooping Querier to participate in the Querier Election
process when it discovers the presence of another Querier in the VLAN. When this mode is
enabled, if the Snooping Querier finds that the other Querier’s source address is better (less)
than the Snooping Querier’s address, it stops sending periodic queries. If the Snooping
Querier wins the election, then it will continue sending periodic queries.
Default
Format set igmp querier election participate
Mode
no set igmp querier election participate
Use this command to set the Snooping Querier not to participate in querier election but go
into non-querier mode as soon as it discovers the presence of another querier in the same
VLAN.
Format no set igmp querier election participate
Mode
show igmpsnooping querier
Use this command to display IGMP Snooping Querier information. Configured information is
displayed whether or not IGMP Snooping Querier is enabled.
Format show igmpsnooping querier [{detail | vlan <vlanid>}]
Mode
When the optional argument <vlanid> is not used, the command displays the following
information.
Global Config
disabled
VLAN Config
VLAN Config
Privileged EXEC
Field Description
Admin Mode
Indicates whether or not IGMP Snooping Querier is active on the switch.
Admin Version
The version of IGMP that will be used while sending out the queries.
Querier
Address
The IP Address which will be used in the IPv4 header while sending out IGMP queries. It
can be configured using the appropriate command.