Filter
Top Products
Switching Commands
140
ProSafe Managed Switch
specify the interface to receive the monitored traffic. Use the mode parameter to enabled the
administrative mode of the session. If enabled, the probe port monitors all the traffic received
and transmitted on the physical monitored port.
Format monitor session <session-id> {source interface <unit/slot/port> [{rx
| tx}] | destination interface <unit/slot/port> | mode}
Mode
no monitor session
Use this command without optional parameters to remove the monitor session (port
monitoring) designation from the source probe port, the destination monitored port and all
VLANs. Once the port is removed from the VLAN, you must manually add the port to any
desired VLANs. Use the source interface <unit/slot/port> parameter or
destination interface <unit/slot/port> to remove the specified interface from
the port monitoring session. Use the mode parameter to disable the administrative mode of
the session
Note: Since the current version of 7000 series software supports only one
session, if you do not supply optional parameters, the behavior of
this command is similar to the behavior of the no monitor
command.
no monitor
This command removes all the source ports and a destination port for the and restores the
default value for mirroring session mode for all the configured sessions.
Note: This is a stand-alone “no” command. This command does not have
a “normal” form.
Global Config
Format no monitor session <session-id> [{source interface <unit/slot/port>
| destination interface <unit/slot/port> | mode}]
Mode
Global Config
Default
enabled
Format no monitor
Mode
Global Config