Filter
Top Products
Quality of Service (QoS) Commands
470
ProSafe Managed Switch
diffserv
This command sets the DiffServ operational mode to active. While disabled, the DiffServ
configuration is retained and can be changed, but it is not activated. When enabled, DiffServ
services are activated.
Format diffserv
Mode
no diffserv
This command sets the DiffServ operational mode to inactive. While disabled, the DiffServ
configuration is retained and can be changed, but it is not activated. When enabled, DiffServ
services are activated.
Format no diffserv
Mode
DiffServ Class Commands
Use the DiffServ class commands to define traffic classification. To classify traffic, you specify
Behavior Aggregate (BA), based on DSCP and Multi-Field (MF) classes of traffic (name,
match criteria)
This set of commands consists of class creation/deletion and matching, with the class match
commands specifying Layer 3, Layer 2, and general match criteria. The class match criteria
are also known as class rules, with a class definition consisting of one or more rules to
identify the traffic that belongs to the class.
Note: Once you create a class match criterion for a class, you cannot
change or delete the criterion. To change or delete a class match
criterion, you must delete and re-create the entire class.
The CLI command root is class-map.
class-map
This command defines a DiffServ class of type match-all. When used without any match
condition, this command enters the class-map mode. The <class-map-name> is a case
sensitive alphanumeric string from 1 to 31 characters uniquely identifying an existing DiffServ
class.
Global Config
Global Config