Filter
Top Products
Utility Commands
584
ProSafe Managed Switch
One IP address is required, although one can specify up to eight addresses in one command
line. Servers are listed in order of preference (address1 is the most preferred server,
address2 is the next most preferred server, and so on).
Default
Format netbios-name-server <address> [<address2>...<address8>]
Mode
no netbios-name-server
This command removes the NetBIOS name server list.
Format no netbios-name-server
Mode
netbios-node-type
The command configures the NetBIOS node type for Microsoft Dynamic Host Configuration
Protocol (DHCP) clients. type specifies the NetBIOS node type. Valid types are:
• b-node—Broadcast
• p-node—Peer-to-peer
• m-node—Mixed
• h-node—Hybrid (recommended)
Default
Format netbios-node-type <type>
Mode
no netbios-node-type
This command removes the NetBIOS node Type.
Format no netbios-node-type
Mode
next-server
This command configures the next server in the boot process of a DHCP client.The
<address> parameter is the IP address of the next server in the boot process, which is
typically a TFTP server.
none
DHCP Pool Config
DHCP Pool Config
none
DHCP Pool Config
DHCP Pool Config
Default
inbound interface helper addresses