Filter
Top Products
Quality of Service (QoS) Commands
499
ProSafe Managed Switch
command parameters are all optional, but the most frequently used parameters appear in the
same relative order as shown in the command format.
The assign-queue parameter allows specification of a particular hardware queue for handling
traffic that matches this rule. The allowed <queue-id> value is 0-(n-1), where n is the
number of user configurable queues available for the hardware platform. The
assign-queue parameter is valid only for a permit rule.
The time-range parameter allows imposing time limitation on the IP ACL rule as defined by
the parameter <time-range-name>. If a time range with the specified name does not exist
and the IP ACL containing this ACL rule is applied to an interface or bound to a VLAN, then
the ACL rule is applied immediately. If a time range with specified name exists and the IP
ACL containing this ACL rule is applied to an interface or bound to a VLAN, then the ACL rule
is applied when the time-range with specified name becomes active. The ACL rule is
removed when the time-range with specified name becomes inactive.
The user can specify a simple rate limiter for packets matching an ACL “permit” rule. The
user needs to specify the burst size in kbytes and allowed rate of traffic in kbps. The
conforming traffic is allowed to transmit, and non-conforming traffic is dropped. This action is
ignored for any “deny” rule, since by definition matching packets are dropped.
Format {deny | permit} {every | {{icmp | igmp | ip | tcp | udp | <number>}
<srcip> <srcmask>[{eq {<portkey> | <0-65535>} <dstip> <dstmask> [{eq
{<portkey>| <0-65535>}] [precedence <precedence> | tos <tos>
<tosmask> | dscp <dscp>] [log] [rate-limit <1-4294967295> <1-128>]
[timerange <time-range-name>] [assign-queue <queue-id>] [{mirror |
redirect}
[lag <lag number> |<unit/slot/port>]]
Mode
ip access-group
This command either attaches a specific IP ACL identified by <accesslistnumber> to an
interface or associates with a VLAN ID in a given direction. The parameter <name> is the
name of the Access Control List.
An optional sequence number may be specified to indicate the order of this IP access list
relative to other IP access lists already assigned to this interface and direction. A lower
number indicates higher precedence order. If a sequence number is already in use for this
interface and direction, the specified access list replaces the currently attached IP access list
using that sequence number. If the sequence number is not specified for this command, a
sequence number that is one greater than the highest sequence number currently in use for
this interface and direction is used.
Note: The <out> option might not be available, depending on the platform.
Ipv4-Access-List Config