Filter
Top Products
Switching Commands
168
ProSafe Managed Switch
LAN interface from its forwarding table entry upon receiving an IGMP leave message for that
multicast group without first sending out MAC-based general queries to the interface.
You should enable fast-leave admin mode only on VLANs where only one host is connected
to each layer 2 LAN port. This prevents the inadvertent dropping of the other hosts that were
connected to the same layer 2 LAN port but were still interested in receiving multicast traffic
directed to that group. Also, fast-leave processing is supported only with IGMP version 2
hosts.
Default
Format set igmp fast-leave
Mode
Format set igmp fast-leave
<vlan_id>
Mode
no set igmp fast-leave
This command disables IGMP Snooping fast-leave admin mode on a selected interface.
Format no set igmp fast-leave
Mode
Format no set igmp fast-leave
<vlan_id>
Mode
set igmp groupmembership-interval
This command sets the IGMP Group Membership Interval time on a VLAN, one interface or
all interfaces. The Group Membership Interval time is the amount of time in seconds that a
switch waits for a report from a particular group on a particular interface before deleting the
interface from the entry. This value must be greater than the IGMPv3 Maximum Response
time value. The range is 2 to 3600 seconds.
Default
Format set igmp groupmembership-interval <2-3600>
Mode
• Interface Config
• Global Config
Format set igmp groupmembership-interval <vlan_id> <2-3600>
Mode
disabled
Interface Config
VLAN Config
Interface Config
VLAN Config
260 seconds
VLAN Config