Filter
Top Products
Management Commands
694
ProSafe Managed Switch
RADIUS Commands
This section describes the commands you use to configure the switch to use a Remote
Authentication Dial-In User Service (RADIUS) server on your network for authentication and
accounting.
authorization network radius
Use this command to enable the switch to accept VLAN assignment by the radius server.
Default
Format authorization network radius
Mode
no authorization network radius
Use this command to disable the switch to accept VLAN assignment by the radius server.
Format no authorization network radius
Mode
radius accounting mode
Use this command to enable the RADIUS accounting function.
Default
Format radius accounting mode
Mode
no radius accounting mode
Use this command to set the RADIUS accounting function to the default value (disabled).
Format no radius accounting mode
Mode
radius server attribute
Use this command to specify the RADIUS client to use the NAS-IP Address attribute in the
RADIUS requests. If the specific IP address is configured while enabling this attribute, the
disable
Global Config
Global Config
disabled
Global Config
Global Config