NETGEAR GSM7228PS-100NAS Switch User Manual


 
Utility Commands
564
ProSafe Managed Switch
Hop Count = 6 Last TTL = 7 Test attempt = 19 Test Success = 18
traceroute ipv6
Use the traceroute command to discover the routes that packets actually take when
traveling to their destination through the network on a hop-by-hop basis. The
<ipv6-address|hostname> parameter must be a valid IPv6 address or hostname. The
optional <port> parameter is the UDP port used as the destination of packets sent as part
of the traceroute. This port should be an unused port on the destination system. The range
for <port> is zero (0) to 65535. The default value is 33434.
Default
Format traceroute ipv6 <ipv6-address|hostname> [port <port>]
Mode
clear config
This command resets the configuration to the factory defaults without powering off the switch.
When you issue this command, a prompt appears to confirm that the reset should proceed.
When you enter y, you automatically reset the current configuration on the switch to the
default values. It does not reset the switch.
Format clear config
Mode
clear eventlog
This command clears all event messages maintained in the switch.
Format clear eventlog
Mode
clear mac-addr-table
This command clears the dynamically learned MAC addresses of the switch.
Format clear mac-addr-table
Mode
clear logging buffered
This command clears the messages maintained in the system log.
Format clear logging buffered
Mode
port: 33434
Privileged EXEC
Privileged EXEC
Privileged EXEC
Privileged EXEC
Privileged EXEC