NETGEAR GSM7228PS-100NAS Switch User Manual


 
IPv6 Multicast Commands
441
ProSafe Managed Switch
show ipv6 mroute source
This command displays the multicast configuration settings specific to IPv6 such as flags,
timer settings, incoming and outgoing interfaces, RPF neighboring routers, and expiration
times of all the entries in the multicast mroute table containing the given source IP address or
source IP address and group IP address pair.
Format show ipv6 mroute source <source-address> {detail | summary}
Modes
• Privileged EXEC
• User EXEC
If you use the detail parameter, the command displays the following column headings in
the output table:
Source IP
Group IP
Expiry Time
Up Time
RPF Neighbor
Flags
If you use the summary parameter, the command displays the following column headings in
the output table:
Term Definition
Source IP
The IP address of the multicast data source.
Group IP
The IP address of the destination of the multicast packet.
Protocol
The multicast routing protocol by which this entry was created.
Incoming
Interface
The interface on which the packet for this group arrives.
Outgoing
Interface List
The list of outgoing interfaces on which this packet is forwarded.
Term Definition
The IP address of the multicast data source.
The IP address of the destination of the multicast packet.
The time of expiry of this entry in seconds.
The time elapsed since the entry was created in seconds.
The IP address of the RPF neighbor.
The flags associated with this entry.
Term Definition
Source IP
The IP address of the multicast data source.
Group IP
The IP address of the destination of the multicast packet.
Protocol
The multicast routing protocol by which this entry was created.