Switching Commands
190
ProSafe Managed Switch
When you specify a value for vlanid, the following information appears.
When the optional argument detail is used, the command shows the global information
and the information for all Querier-enabled VLANs.
Port Security Commands
This section describes the commands you use to configure Port Security on the switch. Port
security, which is also known as port MAC locking, allows you to secure the network by
locking allowable MAC addresses on a port. Packets with a matching source MAC address
are forwarded normally, and all other packets are discarded.
Note: To enable the SNMP trap specific to port security, see snmp-server
enable traps violation on page 686.
Field Description
VLAN Admin
Mode
Indicates whether MLD Snooping Querier is active on the VLAN.
VLAN Operational
State
Indicates whether MLD Snooping Querier is in “Querier” or “Non-Querier” state. When
the switch is in Querier state, it will send out periodic general queries. When in
Non-Querier state, it will wait for moving to Querier state and does not send out any
queries.
Operational Max
Response Time
Indicates the time to wait before removing a Leave from a host upon receiving a Leave
request. This value is calculated dynamically from the Queries received from the
network. If the Snooping Switch is in Querier state, then it is equal to the configured
value.
Querier Election
Participate
Indicates whether the MLD Snooping Querier participates in querier election if it
discovers the presence of a querier in the VLAN.
Querier VLAN
Address
The IP address will be used in the IPv6 header while sending out MLD queries on this
VLAN. It can be configured using the appropriate command.
Operational
Version
This version of IPv6 will be used while sending out MLD queriers on this VLAN.
Last Querier
Address
Indicates the IP address of the most recent Querier from which a Query was received.
Last Querier
Version
Indicates the MLD version of the most recent Querier from which a Query was received
on this VLAN.