Filter
Top Products
Quality of Service (QoS) Commands
504
ProSafe Managed Switch
forwarded to the specified <unit/slot/port>. The assign-queue and redirect
parameters are only valid for a permit rule.
The time-range parameter allows imposing time limitation on the IPv6 ACL rule as defined by
the parameter <time-range-name>. If a time range with the specified name does not exist and
the IPv6 ACL containing this ACL rule is applied to an interface or bound to a VLAN, then the
ACL rule is applied immediately. If a time range with specified name exists and the IPv6 ACL
containing this ACL rule is applied to an interface or bound to a VLAN, then the ACL rule is
applied when the time-range with specified name becomes active. The ACL rule is removed
when the time-range with specified name becomes inactive.
Format {deny | permit} {every | {{icmp | igmp | ipv6 | tcp | udp |
<number>}[log] [timerange
<time-range-name>] [assign-queue <queue-id>] [{mirror | redirect}
<unit/slot/port>]
Mode
ipv6 traffic-filter
This command either attaches a specific IPv6 ACL identified by <name> to an interface or
associates with a VLAN ID in a given direction. The <name> parameter must be the name of
an existing IPv6 ACL.
An optional sequence number may be specified to indicate the order of this mac access list
relative to other IPv6 access lists already assigned to this interface and direction. A lower
number indicates higher precedence order. If a sequence number is already in use for this
interface and direction, the specifiedIPv6 access list replaces the currently attached IPv6
access list using that sequence number. If the sequence number is not specified for this
command, a sequence number that is one greater than the highest sequence number
currently in use for this interface and direction is used.
This command specified in Interface Config mode only affects a single interface, whereas the
Global Config mode setting is applied to all interfaces. The vlan keyword is only valid in the
Global Config mode. The Interface Config mode command is only available on platforms that
support independent per-port class of service queue configuration.
Note: You should be aware that the <out> option may or may not be
available, depending on the platform.
IPv6-Access-List Config
Format ipv6 traffic-filter <name> {{control-plane|in|out}|vlan <vlan-id>
{in|out}} [sequence <1-4294967295>]
Modes
• Global Config
• Interface Config