Filter
Top Products
Switching Commands
182
ProSafe Managed Switch
no set mld interfacemode
Use this command to disable MLD Snooping on all interfaces.
Format no set mld interfacemode
Mode
set mld fast-leave
Use this command to enable MLD Snooping fast-leave admin mode on a selected interface
or VLAN. Enabling fast-leave allows the switch to immediately remove the Layer 2 LAN
interface from its forwarding table entry upon receiving and MLD done message for that
multicast group without first sending out MAC-based general queries to the interface.
Note: You should enable fast-leave admin mode only on VLANs where
only one host is connected to each Layer 2 LAN port. This prevents
the inadvertent dropping of the other hosts that were connected to
the same layer 2 LAN port but were still interested in receiving
multicast traffic directed to that group.
Note: Fast-leave processing is supported only with MLD version 1 hosts.
no set mld fast-leave
Use this command to disable MLD Snooping fast-leave admin mode on a selected interface.
Format no set mld fast-leave vlanid
Mode
• Interface Config
• VLAN Mode
set mld groupmembership-interval
Use this command to set the MLD Group Membership Interval time on a VLAN, one interface
or all interfaces. The Group Membership Interval time is the amount of time in seconds that a
switch waits for a report from a particular group on a particular interface before deleting the
Global Config
Default
disabled
Format set mld fast-leave
vlanid
Mode
• Interface Config
• VLAN Mode