Filter
Top Products
Routing Commands
275
ProSafe Managed Switch
show ip vrrp interface
This command displays all configuration information and VRRP router statistics of a virtual
router configured on a specific interface. Use the output of the command to verify the track
interface and track IP route configurations.
Format show ip vrrp interface {<interface-name> <vrid> }
Modes
• Privileged EXEC
• User EXEC
Primary IP
Address
VMAC address
Authentication
type
Priority
Configured
Priority
Advertisement
interval
Pre-Empt Mode
Administrative
Mode
State
The following shows example CLI display output for the command.
(Switch)#show ip vrrp interface 1/0/1 1
Primary IP Address............................. 1.1.1.5
VMAC Address................................... 00:00:5e:00:01:01
Authentication Type............................ None
Priority....................................... 100
Configured priority.......................... 100
Advertisement Interval (secs).................. 1
Pre-empt Mode.................................. Enable
Administrative Mode............................ Disable
Accept Mode.................................... Enable
State.......................................... Initialized
Track Interface State DecrementPriority
--------------- ------ ------------------
<1/0/1> down 10
TrackRoute (pfx/len) State DecrementPriority
------------------------ ------ ------------------
10.10.10.1/255.255.255.0 down 10
Term Definition
The configured IP address for the Virtual router.
The VMAC address of the specified router.
The authentication type for the specific virtual router.
The priority value for the specific virtual router, taking into account any priority
decrements for tracked interfaces or routes.
The priority configured through the ip vrrp <vrid> priority <1-254> command.
The advertisement interval in seconds for the specific virtual router.
The preemption mode configured on the specified virtual router.
The status (Enable or Disable) of the specific router.
The state (Master/backup) of the virtual router.