Filter
Top Products
TMPR3901F
216
NAME I/O DESCRIPTION
BUSGNT*
O Bus grant signal. Used by TMPR3901F to indicate it has released bus
mastership in response to a request by an external bus master.
XIN I Connect to crystal oscillator.
XOUT O Connect to crystal oscillator.
PLLOFF* I Stops internal PLL oscillation.
CLKEN I Enables internal PLL clock.
SYSCLK
O System clock signal. TMPR3901F bus operation is based on SYSCLK. The
frequency can be reduced by 1/2, 1/4 or 1/8 using reduced frequency mode.
FCLK
O Free clock signal. Outputs master clock independent of reduced frequency
mode (quadruple frequency of crystal oscillator).
FCLKEN
I Free clock enable signal. Specifies whether or not to output FCLK. Tie high
or low.
RESET* I Reset signal. When asserted for at least 12 SYSCLK, resets TMPR3901F.
NMI*
I Non-maskable interrupt signal. On transition from high to low,
TMPR3901F generates a non-maskable interrupt.
INT[5:0]*
I Interrupt signals. At low, TMPR3901F acknowledges as external interrupt.
Keep low until TMPR3901F starts interrupt handling.
HALT O Halt signal. Indicates that TMPR3901F is in halt mode.
DOZE O Doze signal. Indicates that TMPR3901F is in doze mode.
ENDIAN I Endian signal. Tie high or low.
H: Big endian
L: Little endian.
HALF*
I Bus divider signal. When low, bus operates at half frequency of system
clock (SYSCLK). Tie high or low.
CPCOND
[3:1]
I Coprocessor condition signal. Condition signal for coprocessor branch
instruction.
DCLK
PCST [2:0]
DSA0/TPC
DBGE
SDI/DINT
DRESET
−
Real-time debugger interface. Connect real-time debugger, or leave these
signals open.
TEST [4:0]
−
Test signals. Leave these signals open.
VDD
−
Connect to power supply.
VDD (for PLL)
−
Connect to power supply. Keep away from other VDD.
VSS
−
Connect to ground.
VSS (for PLL)
−
Connect to power supply. Keep away from other VSS.
* Active-low signal
4.