Filter
Top Products
4–19
COPYRIGHT
©
1998 CANON INC. CANON NP6621 REV.0 FEB. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
MECHANICAL SYSTEM
5) Remove the two E-rings i, and remove the two
bushings o.
6) Remove the spring !0 of the actuator.
7) Remove the three screws !1, and remove the
solenoid mounting plate !2.
Figure 4-317
Caution:
Take care so that the plunger of the solenoid will
not fall.
8) Loosen the hex nut !3, and remove the spring
clutch !4.
Figure 4-318
6. Positioning the Multifeeder Assem-
bly Paper Guide Plate Cam
Temporarily fix the screw with a hex nut of the
spring clutch assembly, and turn the control ring. At
this time, make adjustments so that the hole in the
cam and the hole (or black dot) in the multifeeder
drive unit match while the claw of the control ring is
in contact with the solenoid plate.
Figure 4-319
9
8
8
9
10
11
12
11
11
13
14
Holes (or hole and black dot) matched
Horizontal line
Screw w/hex nut
Control ring
Gear
Claw
Solenoid plate
Gear
Paper guide plate cam