Filter
Top Products
5–13
INSTALLATION
COPYRIGHT
©
1998 CANON INC. CANON NP6621 REV.0 FEB. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
Remarks
To enter settings,
• Select ‘No. 313’ in service mode, and enter the setting
recorded on the label (PRIMARY) using the keypad. (To
enter ‘–’, press the % key before entering the setting.)
Then, press the Start key to store the setting.
To enter the setting for IP_OFST, select ‘No. 314’ in
service mode and work in the same way.
The copier automatically sets the APVC value; it stops in
about 23 sec.
Follow image adjustment procedure.
(See the Service Handbook P.1-5.)
Step
8
9
10
11
12
13
14
15
Work
Turn on the door switch using the
door switch actuator; then, shift the
power switch to ‘ON’.
Only the European model, in case
of the other model, go to next step.
Select service mode No. 313/314,
and enter the settings recorded on
the drum label.
To select service mode,
• Press the service mode switch
(SW850) with a hex key.
Select ‘3’ of the mode by press-
ing ‘3’ on the keypad and AE
key; then, select ‘No. 3 xx’ by
pressing ‘x’ and ‘x’ on the keypad
and the Start key.
Turn off the power, and open the
copier’s top unit.
Replace the static eliminator, and
close the copier's top unit.
Close the front door, and turn on
the power.
Only the European model, in case
of the other model, go to next step.
Execute ‘No. 412’ in service mode.
• Press the service mode swicth
(SW850), ‘4’ on the keypad, AE
key, ‘1’ and ‘2’ on the keypad,
and Start key in sequence.
Remove the door switch actuator,
and close the front door.
Place the test sheet and check
copy.
Service mode switch