Filter
Top Products
5–5
INSTALLATION
COPYRIGHT
©
1998 CANON INC. CANON NP6621 REV.0 FEB. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
B. Turning On the Copier
Work
Connect the power plug to the
power outlet.
Turn on the power switch.
Turn off the power switch.
Supply toner according to the
instructions given on the toner
supply label attached behind the
front door.
Release the developing assembly
by the developing assembly
locking lever.
Install the drum unit.
Lock the developing assembly,
and close the copier’s top unit.
Insert the door switch activator into
the door switch, and turn on the
power.
In others model except European
model, this procedure is not
necessary.
Go to step 10).
Select service mode No. 313/314,
and enter the settings recorded on
the drum label.
To select service mode,
• Press the service mode switch
(SW850) with a hex key.
Select ‘3’ of the mode by press-
ing ‘3’ on the keypad and AE
key; then, select ‘No. 3 xx’ by
pressing ‘x’ and ‘x’ on the keypad
and the start key.
Remarks
Caution:
• Make sure that the power outlet is the rating ±10%.
Make sure that the Add Paper message flashes.
• Press the keypad and the Clear key to make sure that
the copy count indication is correct.
Caution:
When turning the toner cartridge counterclockwise to
set it, you must fully turn it until it is locked; the develop-
ing assembly can cause a fault if you operate the
machine without locking the cartridge.
See “D. Attaching the Drum Unit.”
To enter settings,
• Select ‘No. 313’ in service mode, and enter the setting
recorded on the label (PRIMARY) using the keypad. (To
enter ‘–’, press the % key before entering the setting.)
Then, press the Start key to store the setting.
To enter the setting for IP_OFST, select ‘No. 314’ in
service mode and work in the same way.
Step
1
2
3
4
5
6
7
8
9
Service mode switch