Filter
Top Products
4–36
COPYRIGHT
©
1998 CANON INC. CANON NP6621 REV.0 FEB. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
MECHANICAL SYSTEM
6. Routing the Blank Shutter Cable
Figure 4-410
7. Adjusting the Left/Right Margin Po-
sition
Turn the blank adjusting screw on the front plate
shown in Figure 4-411 so that the measurements
meet the standards.
q CW turn: moves the margin to the front
w CCW turn: moves the margin to the rear
e full turn: moves about 1 mm
Figure 4-411
Attach the spring the outside
of the slide shutter.
Slide shutter (rear)
Wind 3.5 items
Slide shutter (front)
1
8. Installing the Mirror Heater
1) Remove the copyboard glass.
2) Install the cord clamp q to the bottom plate of
the lens mount.
3) Install the mirror heater e with a screw w.
Figure 4-412
4) Connect the connector r.
5) Set the lens heater harness t to the cord
clamp.
Figure 4-413
6) Install the copyboard glass.
4
5
1
2
3