Filter
Top Products
4–20
COPYRIGHT
©
1998 CANON INC. CANON NP6621 REV.0 FEB. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
MECHANICAL SYSTEM
C. Registration Roller Assem-
bly
1. Removing the Registration Clutch
1) Remove the lower rear cover.
2) Remove the clip ring q, and disconnect the
connector w; then, remove the registration
clutch e.
Figure 4-322
2. Removing the Upper Registration
Roller
1) Remove the registration clutch. (See “Remov-
ing the Registration Clutch.”)
2) Remove the springs (front) q and (rear) w.
Figure 4-323
7. Adjusting the Left/Right Registration
If the left/right registration is wrong when using
the multifeeder, loosen the screws q to adjust the
tray position.
Figure 4-321
8. Points to Note When Installing the
Multifeeder Assembly Rack Plate
Install the multifeeder rack plate to the pulley
with both left and right rack plates fully open.
1
Caution:
If the adjusting hole is not furnished with a black
dot for reference, make adjustments as in-
structed while making sure that the paper guide
plate cam of the multifeeder aseembly is lo-
cated as shown.
Figure 4-320
130.5±0.5mm
Paper guide
plate cam
Hole
2
1
3
1