Filter
Top Products
4–30
COPYRIGHT
©
1998 CANON INC. CANON NP6621 REV.0 FEB. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
MECHANICAL SYSTEM
14
3
1
4
2
4
3
2
6) Remove the six mounting screws t, and re-
move the pick-up assembly.
Figure 4-361
5. Removing the Pick-Up Roller
1) Remove the pick-up assembly.
2) Remove the stop ring q, and remove the pick-
up roller w together with the roller collar.
Figure 4-362
5
2
1
11) Remove the mounting screw !4, and remove
the wire together with the mounting support.
Figure 4-359
4. Removing the Pick-Up Assembly
1) Open the right door of the pedestal, and slide
out the paper deck to the front about 10 cm.
Caution:
• For the paper deck pedestal, slide out only the
paper deck.
• Do not try to detach the pick-up assembly
without removing the paper deck from the
pedestal; the lifter will make the removal of
the pick-up assembly impossible.
• Do not slide out the paper deck too far toward
the front; doing so would cause the pedestal
to tilt to the front when the pick-up assembly
is removed.
2) Remove the right cover.
3) Remove the screw q; then, remove the stop
plate.
4) Remove the eight mounting screws w, and
remove the two support plates e.
5) Disconnect the four connectors r.
Figure 4-360