Filter
Top Products
Reference for the Passport 8000 Series Command Line Interface Routing Operations
5-6 208967-B
Figure 5-5 shows a sample of the config ip dvmrp info command.
Passport-8610# config ip dvmrp info
Sub-Context:
Current Context:
enable : true
update-interval : 60
triggered-update-interval : 5
leaf-timeout : 200
nbr-timeout : 35
nbr-probe-interval : 10
Figure 5-5.
config ip dvmrp info
Command Output
config ip dvmrp interface Commands
The
config ip dvmrp interface commands require an IP address <ipaddr>
and use the following syntax and parameters:
show ip dvmrp Commands
These commands display information about DVMRP as set on the switch.
show ip dvmrp info Command
The
show ip dvmrp info command displays information about the general
DVMRP group.
The command uses the syntax:
show ip dvmrp info
config ip dvmrp interface <ipaddr>
followed by:
info Displays information about the specified DVMRP
local router interface.
disable Disables DVMRP on the local router interface.
enable Enables DVMRP on the local router interface.
metric <cost> Sets the cost metric (maximum number of hops) for
the router interface.
• <cost> istherangeof1to31.
cli.book Page6 Wednesday,April19, 2000 3:14PM