Filter
Top Products
Reference for the Accelar 8000 Series Command Line Interface Routing Operations
8-8 208967-A
config ip traffic-filter filter Commands
The
config ip traffic-filter filter commands allow you to set up traffic
filters where <fid> is the traffic filter ID (1 to 4000).
The commands take the following syntax and parameters:
config ip traffic-filter filter <fid> action Commands
The
config ip traffic-filter filter <fid> action commands are used to
set action parameters for IP filters by enabling or disabling the filters where <fid>
is the traffic filter ID (1 to 4000).
The commands use the following syntax and parameters:
config ip traffic-filter filter <fid>
followed by:
info Displays the settings for the specified filter.
delete Deletes the specified traffic filter.
name <name> Names the filter.
• name <value> is the IP filter name {string}.
config ip traffic-filter filter <fid> action
followed by:
info Displays configure actions for the filter.
mode
<default|forward|drop>
Sets the action to occur when a filter is applied.
• <default|forward|drop> are the choices:
default action, forward the packet, or drop the
packet.
mirror <enable|disable> Enables or disables the traffic filter mirror option.
statistic
<enable|disable>
Enables or disables the option to collect statistics on
the traffic filter. The default setting is disable.
If disabled, the show ip traffic-filter stats
command will display zeros for this filter.
cli.book Page8 Wednesday,April19, 2000 3:14PM