Filter
Top Products
IP QoS and Traffic Filter Commands
208967-A 8-13
config ip traffic-filter global-set Commands
The
config ip traffic-filter global-set commands allow you to set a
global filter and use a global set ID <gsetid> between 1 and 100.
The commands use the following syntax and parameters:
Figure 8-7
shows an example of the config ip traffic-filter global-set
info
command.
Passport-8610/config/ip/traffic-filter# global-set 1 info
Sub-Context: create filter global-set set traffic-profile
Current Context:
create :
name -
delete : N/A
add-filter : 2
remove-filter : N/A
Figure 8-7.
config ip traffic-filter global-set info
Command Output
config ip traffic-filter set Commands
The
config ip traffic-filter set commands allow you to configure the
source/destination set where
<setid> is the set ID (300 to 1000). Only source/
destination filters can be added to this set. You cannot add a global filter to it.
config ip traffic-filter global-set <gsetid>
followed by:
info Displays the global set characteristics.
add-filter <fid> Adds a global filter to a global set.
• <fid> is the traffic filter ID range of 1 to 4000.
create [name <value>] Creates a global set.
• [name <value>] sets a name
to the filter.
delete Deletes a global set.
remove-filter <fid> Removes a global filter from a global set.
• <fid> is the traffic filter ID range of 1 to 4000.
cli.book Page13 Wednesday, April 19,2000 3:14 PM