Filter
Top Products
Reference for the Passport 8000 Series Command Line Interface Routing Operations
3-2 208967-B
These commands are as follows:
config ip rip
followed by:
info Displays current RIP configuration settings.
disable Globally disables RIP on the switch.
domain <ipaddr> <value> Changes the RIP interface configuration domain, the
value inserted into the routing domain field of all RIP
packets sent on this interface.
• <ipaddr> is the interface IP address {a.b.c.d}.
• <value> is the domain value {0 to 39321}.
enable Globally enables RIP on the switch.
holddown <seconds> Sets the RIP holddown timer value, the length of time
(in seconds) that RIP will continue to advertise a
network after determining that it is unreachable.
• <seconds> is0to360,withadefaultof120.
updatetime <seconds> Sets RIP update timer, the time interval between RIP
updates.
• <seconds> is0to360,withadefaultof
30 seconds.
receive <ipaddr> mode
<value>
Changes the RIP interface receive configuration.
• <ipaddr> is the IP address of the interface.
• mode <value> indicates what RIP versions to
accept:
• rip1 =RIPversion1.
• rip2 =RIPversion2.
• rip1orrip2= receive in either RIP 1 or 2.
send <ipaddr> mode
<value>
Changes the RIP interface send configuration.
• <ipaddr> is the IP address of the interface.
• mode <value> indicates what RIP versions to
send:
• notsend = do not send
• rip1 =RIPversion1.
• rip2 =RIPversion2.
• rip1Compatible= receive in either RIP 1 or
2.
cli.book Page2 Wednesday,April19, 2000 3:14PM