Filter
Top Products
Reference for the Passport 8000 Series Command Line Interface Routing Operations
7-8 208967-B
config ip policy rip Commands
The
config ip policy rip commands are used to apply the configured RIP
accept or announce policies to the switch. Use the config ip policy rip info
command to display the current status.
config ip policy rip accept Commands
The
config ip policy rip accept commands allow you to configure the RIP
accept policy, where <pid> is the RIP accept policy ID (4001 to 5000).
The commands use the following syntax and parameters:
config ip policy rip accept <pid>
followed by:
info Displays the settings for the RIP accept policy.
action <accept|ignore> Selects whether the RIP policy action will be
to accept or ignore matches.
apply-mask <ipmask> Sets an IP subnet mask for the RIP accept
policy, where <ipmask> is the apply-mask
{a.b.c.d}.
create Creates a RIP accept policy.
delete Deletes a RIP accept policy.
disable Disables a RIP accept policy.
enable Enables a RIP accept policy.
exact-netlist <netlist id> Sets a RIP accept policy in which networks
will only match the specific network
advertisement.
• <netlist id> is the netlist id range
to 1000.
inject-netlist <netlist id> Sets a RIP accept policy that will insert
networks into the routing table that differ from
the actual advertised network.
• <netlist id> is the netlist id range
0 to 1000.
name <string> Assigns a RIP accept policy name.
precedence <precedence> Sets the precedence for the RIP accept policy.
The range is 0 to 65535. If multiple policies
apply, the higher precedence is used.
cli.book Page8 Wednesday,April19, 2000 3:14PM