Filter
Top Products
IPX Commands
208967-B 6-7
config ipx rip Commands
These commands allow you to configure Routing Information Protocol (RIP) on
IPX interfaces. Three timing parameters (hold-multiplier, delay-timer, and
interval-timer) control IPX RIP behavior. If you do not use the factory defaults
and change global default parameters, you should set the global parameters prior
to setting individual interface parameters.
config ipx rip info Command
The
config ipx rip info command displays IPX RIP settings on the switch.
The command uses the syntax:
config ipx rip info
config ipx rip default Commands
The
config ipx rip default commands allow you to set the IPX RIP default
values using the following syntax and parameters:
config ipx rip
followed by:
default-delay <delay-timer> Sets the delay timer default values in
milliseconds.
• <delay-timer> is the range of 1 to 1000
with the default of 50 ms.
default-hold-multiplier
<hold-multiplier>
Sets the hold multiplier default value.
• <hold-multiplier> is the range of 1 to
2147483647 with the default of 3.
default-interval
<interval-timer>
Sets the interval timer default values in seconds.
• <interval-timer> is the range of 1 to
2147483647 with the default of 60 seconds.
cli.book Page7 Wednesday,April19, 2000 3:14PM