Filter
Top Products
Reference for the Passport 8000 Series Command Line Interface Routing Operations
4-2 208967-B
The commands use the following syntax and parameters:
Figure 4-1
shows the config ethernet ip vrrp info command.
Passport-8610# config ethernet 3/2 ip vrrp 1 info
Sub-Context:
Current Context:
Port 3/2 :
address : 10.10.40.10
adver-int : 1
critical-ip : 10.10.40.15
delete : N/A
vrrp : enable
priority : 100
Figure 4-1.
config ethernet ports ip vrrp info
Command Output
config ethernet <ports> ip vrrp <vrid>
followed by:
info Displays the current port VRRP configuration.
address <ipaddr> Sets the IP address of the virtual router interface.
adver-int <seconds> Sets the advertising interval (in seconds), the time
interval between sending VRRP advertisement
messages. The value must be the same on all
participating routers. The range is 1 to 255, and
the default is 1.
critical-ip <ipaddr> Sets the critical IP address for VRRP. This address
is an IP interface on the local router configured so
that a change in its state causes a role switch in
the virtual router (for example, from master to
backup in case the interface went down).
delete Deletes VRRP from the port.
disable Disables VRRP on the port.
enable Enables VRRP on the port.
priority <prio> Sets the port VRRP priority (1 to 254) value to be
used by this VRRP router. The default is 100. The
value 255 is assigned to the router that owns the
IP address associated with the virtual router.
cli.book Page2 Wednesday,April19, 2000 3:14PM