Filter
Top Products
Reference for the Passport 8000 Series Command Line Interface Routing Operations
1-12 208967-B
Figure 1-12 shows a sample of the config ip arp info command.
Passport-8610# config ip arp info
Sub-Context:
Current Context:
aging : 360
delete : N/A
add :
ports - 1/30
ip - 10.10.40.142
mac - 00:e0:16:68:8c:00
vlan - 1
ports - 1/2
ip - 10.10.40.194
mac - 00:e0:16:7f:16:00
vlan - 1
Figure 1-12.
config ip arp info
Command (Partial Output)
show ip arp info Command
The show ip arp info command displays the ARP table.
The command uses the format:
show ip arp info [<ip address>] [-s <value>]
where:
[<ip address>] is the specific net IP address for the table.
[-s <value>]
is the specific subnet in the format
(a.b.c.d/x|a.b.c.d/x.x.x.x|default).
An example of the output from this command with no IP address or subnet
specified is shown in Figure 1-13
. In the TTL column, the output is measured in
seconds.
cli.book Page12 Wednesday, April 19,2000 3:14 PM