Filter
Top Products
Reference for the Passport 8000 Series Command Line Interface Routing Operations
3-10 208967-B
show vlan info rip Command
The
show vlan info rip command shows the RIP parameters for all VLANs or
for the specified VLAN.
The command uses the format:
show vlan info rip [<vid>]
Figure 3-7 is an example.
Passport-8610# show vlan info rip
================================================================================
Vlan Rip
================================================================================
VLAN ADVERTISE ACCEPT TRIGGERED AUTOAGG
ID ENABLE DEFAULT DEFAULT UPDATE ENABLE SUPPLY LISTEN POISON
--------------------------------------------------------------------------------
1 false false false false false true true false
2 false false false false false true true false
3 false false false false false true true false
4 false false false false false true true false
Figure 3-7.
show vlan info rip
Command Output
OSPF Commands
Routers use the Open Shortest Path First (OSPF) protocol to exchange network
topology information among themselves, providing each router with a map of the
network.
config ip ospf Commands
The following command groups are used to configure OSPF on the switch:
•
config ip ospf commands (this page)
•
config ip ospf host-route commands (page 3-12)
•
config ip ospf interface commands (page 3-13)
•
config ip ospf area commands (page 3-15)
•
config ip ospf area range commands (page 3-16)
cli.book Page10 Wednesday, April 19,2000 3:14 PM