Filter
Top Products
RIP and OSPF Commands
208967-B 3-5
auto-aggr <enable|disable> Enables or disables automatic route
aggregation on the port. When enabled, the
router switch automatically aggregates
routes to their natural mask when they are
advertised on an interface in a different class
network. The default is disable.
default-listen <enable|disable> Enables or disables RIP listen to accept the
default route via RIP.
default-supply <enable|disable> Enables or disables an advertisement of a
default route only if one exists in the routing
table.
disable Disables RIP on the port. This setting is the
default.
enable Enables RIP on the port.
listen <enable|disable> Configures whether or not the switch will
listen for a default route without listening for
all routes.
manualtrigger Allows you to manually issue a RIP update.
poison <enable|disable> Sets whether or not RIP routes on the port
learned from a neighbor are advertised back
to the neighbor. If disabled, split horizon is
invoked and IP routes learned from an
immediate neighbor are not advertised back
to the neighbor. If enabled, the RIP updates
sent to a neighbor from which a route is
learned are “poisoned” with a metric of 16.
Therefore, the receiver neighbor will ignore
this route because the metric 16 indicates
infinite hops in the network.
supply <enable|disable> Enables or disables the switch to supply RIP
routes with including the default routes.
trigger <enable|disable> Enables or disables automatic triggered
updates for RIP.
config ethernet <ports> ip rip
followed by:
cli.book Page5 Wednesday,April19, 2000 3:14PM