Filter
Top Products
Policies Commands
208967-B 7-3
config ip policy netlist Commands
The
config ip policy netlist commands allow you to set network list
matching criteria to suit a given route where <listid> is the network list ID
(1 to 1000).
The commands use the following syntax and parameters:
Figure 7-2
shows an example of the config ip policy netlist info
command.
Passport-8610# config ip policy netlist 3 info
Sub-Context:
Current Context:
create :
delete : N/A
name : NETLIST#3
add-network :
remove-network : N/A
Figure 7-2.
config ip policy netlist info
Command Output
config ip policy netlist <listid>
followed by:
info Displays settings for the IP policy network list.
add-network
<ipaddr/mask>
Adds a network with the IP address and subnet mask
to the policy network list.
create Creates a policy network list.
delete Deletes the policy network list.
name <name> Assigns a name to the policy network list.
remove-network
<ipaddr/mask>
Removes an address from the policy address list.
cli.book Page3 Wednesday,April19, 2000 3:14PM