Filter
Top Products
RIP and OSPF Commands
208967-B 3-9
Refer to Table 3-1 on page 3-6 for actions resulting from RIP supply and listen
settings.
Figure 3-6
shows a sample of the config vlan ip rip info command.
Passport-8610# config vlan 1 ip rip info
Sub-Context:
Current Context:
advertise-when-down : disable
auto-aggr : disable
default-listen : disable
default-supply : disable
rip : disable
trigger : disable
listen : enable
manualtrigger : N/A
poison : disable
supply : enable
Figure 3-6.
config vlan ip rip info
Command Output
poison <enable|disable> Sets whether or not RIP routes on the VLAN
learned from a neighbor are advertised back to the
neighbor. If disabled, split horizon is invoked and
IP routes learned from an immediate neighbor are
not advertised back to the neighbor. If enabled, the
RIP updates sent to a neighbor from which a route
is learned are “poisoned” with a metric of 16.
Therefore, the receiver neighbor ignores this route
because the metric 16 indicates infinite hops in the
network.
supply <enable|disable> Enables or disables the switch to supply RIP
updates.
trigger <enable|disable> Enables or disables automatic triggered updates
for RIP.
config vlan <vid> ip rip
followed by:
cli.book Page9 Wednesday,April19, 2000 3:14PM