Filter
Top Products
208967-B 3-1
Chapter 3
RIP and OSPF Commands
This chapter describes the Run-Time CLI commands that are used to configure
RIP and OSPF layer 3 (routing) functions in the Passport 8000 Series switch. The
chapter includes sections about the following command groups used to configure
routing characteristics:
• RIP Commands
• OSPF Commands
RIP Commands
This section describes the commands used to configure Routing Information
Protocol (RIP) on the Passport 8000 Series switch. You configure RIP on a port or
on a VLAN, but you must enable it globally first.
config ip rip Commands
The config ip rip commands allow you to enable or disable RIP globally on
the switch.
cli.book Page1 Wednesday,April19, 2000 3:14PM