Filter
Top Products
Reference for the Passport 8000 Series Command Line Interface Routing Operations
1-8 208967-B
show ports info ip Command
The
show ports info ip command displays routing (IP) information about the
specified port or for all ports.
This command uses the syntax:
show ports info ip [<ports>]
Figure 1-8 is a sample display.
Passport-8610# show ports info ip
================================================================================
Port Ip
================================================================================
PORT IP_ADDRESS NET_MASK BROADCAST REASM ADVERTISE
NUM MAXSIZE WHEN_DOWN
--------------------------------------------------------------------------------
9/13 5.5.5.5 255.0.0.0 ones 1500 disable
Figure 1-8.
show ports info ip
Command Output
Brouter Ports
To create a brouter port, configure a routed IP policy-based single-port VLAN.
You create a brouter port by assigning an IP address to a port and specifying a
VLAN ID for that port. Use the following command:
config ethernet <ports> ip create <ipaddr/mask> <vid>
cli.book Page8 Wednesday,April19, 2000 3:14PM