Filter
Top Products
Reference for the Passport 8000 Series Command Line Interface Routing Operations
3-4 208967-B
show ip rip interface Command
The
show ip rip interface command displays information about the specified
RIP interface or all RIP interfaces on the switch.
The command uses the syntax:
show ip rip interface [<ipaddr>]
Figure 3-3 is a sample display.
Passport-8610# show ip rip interface
================================================================================
Rip Interface
================================================================================
IP_ADDR RIP_ENABLE SEND RECEIVE
--------------------------------------------------------------------------------
5.5.5.5 false rip1Compatible rip1OrRip2
Figure 3-3.
show ip rip interface
Command Output
config ethernet <ports> ip rip Commands
The config ethernet <ports> ip rip commands configure RIP on specified
ports. RIP must also be enabled globally for the commands to take effect. These
commands use the
<ports> parameter to specify the ports for which you are
entering the command in the form portlist {slot/port[-slot/port][, ...]}.
The port-based RIP commands have the following syntax and parameters:
config ethernet <ports> ip rip
followed by:
info Displays RIP characteristics on the port.
advertise-when-down
<enable|disable>
If enabled, the network on this interface is
advertised as up, even if the port is down.
The default is disabled.
Note: When you configure a port without any
link and enable advertise-when-down, it will
not advertise your route until the port is
active. Then the route will be advertised
even when the link is down. To disable
advertising based on link status, this
parameter should be disabled.
cli.book Page4 Wednesday,April19, 2000 3:14PM