Filter
Top Products
RIP and OSPF Commands
208967-B 3-11
• config ip ospf area virtual-interface commands (page 3-17)
config ip ospf Commands
Use the
config ip ospf commands to configure global OSPF parameters for
the Passport 8000 Series switch as follows:
config ip ospf
followed by:
info Displays the current OSPF configuration on the
switch.
admin-state
<enable|disable>
Globally enables or disables the OSPF
administrative status. The default is disable.
as-boundary-router
<enable|disable>
Enables or disables the OSPF Autonomous System
boundary router.
auto-vlink
<enable|disable>
Enables or disables automatic creation of OSPF
virtual links when required. The default is disable.
default-metric
[ethernet <value>]
[fast-ethernet <value>]
[gig-ethernet <value>]
Sets the OSPF default metrics. The range is 1 to
65535.
• [ethernet <value>] is for the 10 Mb/s
Ethernet (default is 100).
• [fast-ethernet <value>] is the 100 Mb/s
(fast) Ethernet (default is 10).
• [gig-ethernet <value>] is the Gigabit (gig)
Ethernet (default is 1).
disable Globally disables OSPF on the switch.
enable Globally enables OSPF on the switch.
holddown <seconds> Sets the OSPF holddown timer value in seconds.
• <seconds> is the range of seconds from 3 to 60;
default is 10.
router-id <ipaddr> Sets the OSPF router ID IP address.
• <ipaddr> is the IP address.
trap <enable|disable> Enables or disables issuing traps relating to OSPF.
cli.book Page11 Wednesday, April 19,2000 3:14 PM