Filter
Top Products
Policies Commands
208967-B 7-9
Figure 7-5 shows an example of the config ip policy rip accept info
command.
Passport-8610/config/ip/policy/rip# accept 4003 info
Sub-Context: accept announce
Current Context:
action : accept
apply-mask : 0.0.0.0
create :
delete : N/A
enable : true
exact-net-list : 0
inject-net-list : 0
name : POLICY-4003
range-net-list : 0
rip-gateway-list : 0
rip-interface-list : 0
precedence : 0
Figure 7-5.
config ip policy rip accept info
Command Output
range-netlist <netlist id> Sets the RIP accept policy to match any
network number that falls into the indicated
range.
• <netlist id> is the netlist id range
0 to 1000.
rip-gateway-list <addrlist id> Identifies the RIP gateway lists that are
associated with this policy.
• <addrlist id> is the RIP gateway list
ID (0 to 1000) and applies only to RIP
sourced routes if RIP is included as a
route source.
rip-interface-list <listid> Indicates the entries in the RIP interface lists
that are associated with this policy.
• <listid> is the RIP interface list ID (0 to
1000) and applies only to RIP sourced
routes if RIP is included as a route source.
config ip policy rip accept <pid>
followed by:
cli.book Page9 Wednesday,April19, 2000 3:14PM