Filter
Top Products
Reference for the Passport 8000 Series Command Line Interface Routing Operations
7-10 208967-B
config ip policy rip announce Commands
The
config ip policy rip announce commands allow you to configure the
RIP announce policy, where <pid> is the RIP announce policy ID (1 to 1000).
The commands use the following syntax and parameters:
config ip policy rip announce <pid>
followed by:
info Displays the settings for the RIP announce
policy.
action <accept|ignore> Selects whether the RIP policy action will be
to accept or ignore matches.
add-route-source
<direct|static|rip|ospf|any>
Adds a route source to the announce policy.
advertise-netlist <netlist id> If the action is set to announce, allows
sending or advertising networks that differ
from the actual network in the routing table
advertise network list.
• <netlist id> isthenetlistidrange0to
1000.
create Creates a RIP announce policy.
delete Deletes a RIP announce policy.
disable Disables a RIP announce policy.
enable Enables a RIP announce policy.
exact-netlist <netlist id> Sets a RIP announce policy exact network list.
• <netlist id> isthenetlistidrange0to
1000.
name <string> Assigns a RIP accept policy name.
ospf-router-id-list
<addrlist id>
Indicates the entries in the OSPF router lists
that are associated with this policy.
• <addrlist id> is OSPF router-id list
{0..1000} . It is valid only for OSPF-routed
sourced routes if OSPF is included as a
route source.
ospf-route-type
<type1|type2|external|
internal|any>
Indicates the entries in the OSPF router lists
that are associated with this policy: type 1,
type 2, external routes, internal routes, or any
OSPF routes.
cli.book Page10 Wednesday, April 19,2000 3:14 PM