Filter
Top Products
Reference for the Passport 8000 Series Command Line Interface Routing Operations
1-10 208967-B
Figure 1-10 shows an example of the config vlan ip info command.
Passport-8610# config vlan 5 ip info
Sub-Context:
Current Context:
create : 5.5.5.5/255.0.0.0 mac_offset 0
delete : N/A
Figure 1-10.
config vlan ip info
Command Output
show vlan info ip Command
The
show vlan info ip command displays the routing (IP) configuration for all
VLANs on the switch or for the specified VLAN.
This command uses the syntax:
show vlan info ip [<vid>]
Figure 1-11 is a sample display.
Passport-8610# show vlan info ip
================================================================================
Vlan Ip
================================================================================
VLAN IP NET BCASTADDR REASM ADVERTISE
ID ADDRESS MASK FORMAT MAXSIZE WHEN_DOWN
-----------------------------------------------------------------------
1 10.10.40.3 255.255.255.0 ones 1500 disable
Figure 1-11.
show vlan info ip
Command Output
IP ARP Commands
The Address Resolution Protocol (ARP) commands enable you to add and delete
static entries in the ARP table and to display the ARP table. The ARP table maps
MAC addresses to IP addresses. If you add an ARP entry for a VLAN, the VLAN
is associated with the MAC address you specify. When you display the ARP table,
all entries (static and dynamic) are displayed. Before you can add an ARP entry to
a port or port-based VLAN, an IP address must already be assigned to the port or
VLAN and routing must already be enabled.
cli.book Page10 Wednesday, April 19,2000 3:14 PM