Filter
Top Products
Reference for the Accelar 8000 Series Command Line Interface Routing Operations
8-12 208967-A
Figure 8-6 shows an example of config ip traffic-filter filter modify
info
command.
Passport-8610:6/config/ip/traffic-filter/filter/1/modify#
info
Sub-Context:
Current Context:
dscp : 000000
dscp-enable : disable
ieee8021p : 0
ieee8021p-enable : disable
Figure 8-6.
config ip traffic-filter filter modify info
Command Output
ieee8021p <integer> If you want IEEE 802.1p bits modified to another value
instead of zero, use this field to specify the value for the
IEEE 802.1p bits. After entering the number, you first
must disable and then enable the traffic filter to ensure
that it takes effect.
• <integer> is a number between 0 and 7.
ieee8021p-enable
<enable|disable>
Enables or disables the traffic filter to modify the IEEE
802.1p bits to zero on packets ingressing a DiffServ
access port only.
Note: When you enable a traffic filter to modify either the DSCP or IEEE
802.1p bits, the traffic filter will also modify the other value based on a
corresponding value in the QoS ingress tables.
config ip traffic-filter filter <fid> modify
followed by:
cli.book Page12 Wednesday, April 19,2000 3:14 PM