Filter
Top Products
208967-B 5-1
Chapter 5
IP Multicast Commands
This chapter describes the Run-Time CLI commands that are used to configure
multicasting functions in the Passport 8000 Series switch. The chapter includes
sections about the following command groups used to configure routing
characteristics:
• IP Multicast Commands
• DVMRP Commands
• Layer 3 IGMP Commands
IP Multicast Commands
The IP multicast commands allow you to configure and view IP multicasting
parameters on the switch.
config ip mroute Commands
The commands to configure multicast routing on the switch take the following
syntax and format, where <ipaddr> is the multicast route interface IP address:
config ip mroute
followed by:
info Displays information about the multicast route.
interface <ipaddr> info Displays information about the multicast route
interface.
mroute interface
<ipaddr> ttl <ttl>
Sets the default time-to-live threshold for the multicast
route interface.
cli.book Page1 Wednesday,April19, 2000 3:14PM