Filter
Top Products
Reference for the Passport 8000 Series Command Line Interface Routing Operations
2-6 208967-B
Passport-8610# show ports stats dhcp-relay
=============================================================
===========
Port Stats Dhcp
===========================================================
=============
PORT_NUM NUMREQUEST NUMREPLY
-----------------------------------------------------------
-------------
1/1 0 0
3/1 0 0
3/2 0 0
3/3 0 0
3/4 0 0
3/5 0 0
Figure 2-4.
show ports stats dhcp-relay
Command (Partial Output)
config vlan <vid> ip dhcp-relay Commands
The config vlan <vid> ip dhcp-relay commands allow you to configure
DHCP routing on the VLAN. The commands require a VLAN ID <vid> from 1
to 4094.
The commands use the following syntax and parameters:
config vlan <vid> ip dhcp-relay
followed by:
info Displays DHCP characteristics on the VLAN.
broadcast <enable|disable> Sets whether or not the server reply is sent as a
broadcast back to the end station.
disable Disables DHCP relaying on the VLAN. This is the
default state.
enable Enables DHCP relaying on the VLAN.
max-hop <max-hop> Sets the maximum number of hops before the
BootP/DHCP packet is dropped (1 to 16).
min-sec <min-sec> Sets the minimum seconds count for DHCP. If the
secs field in the packet header is greater than this
value, the switch forwards the packet; otherwise it
is dropped (0 to 65535).
mode <mode> Sets DHCP mode to forward BootP messages
only, DHCP messages only, or both. The default is
both.
cli.book Page6 Wednesday,April19, 2000 3:14PM