Filter
Top Products
Reference for the Passport 8000 Series Command Line Interface Routing Operations
1-2 208967-B
forwarding disable Disables IP forwarding (routing) on the entire switch. IP
routing is disabled, allowing you to manage a Passport
switch over a network without forcing the switch to also
perform routing.
forwarding enable Enables IP forwarding (routing) on the entire switch.
Default is enable.
forwarding info Displays whether IP forwarding is enabled or disabled.
mroute info Displays IP multicast route settings.
mroute interface
<ipaddr> info
Displays IP multicast routing interface information.
mroute interface
<ipaddr> ttl <ttl>
Sets the default time-to-live for the multicast route
interface.
route delete
<ipaddr/mask>
Deletes a route.
• <ipaddr/mask> is the IP address and mask for the
route’s destination.
route info Displays route information.
route-discovery
disable
Disables Internet Router Discovery Protocol (IRDP). This
command will be fully implemented in a future release.
route-discovery enable Enables IRDP. This command will be fully implemented in
a future release.
route-discovery info Displays whether route discovery is enabled or disabled.
static-route create
<ipaddr/mask> next-hop
<value> cost <value>
Adds a static or default route to the switch.
• <ipaddr/mask> is the IP address and mask for the
route’s destination.
• next-hop <value> is the IP address of the next
hop router; the next router at which packets must
arrive on this route.
• cost <value> is the metric of the route.
static-route delete
<ipaddr/mask> next-hop
<value>
Deletes a static route.
• <ipaddr/mask> is the IP address and mask for the
route’s destination.
• next-hop <value> is the IP address of the next
hop router; the next router packets must arrive at on
this route.
config ip
followed by:
cli.book Page2 Wednesday,April19, 2000 3:14PM