Filter
Top Products
Reference for the Passport 8000 Series Command Line Interface Routing Operations
5-10 208967-B
The DVMRP port commands require the parameter <ports> as the port or list of
ports for the command {slot/port[-slot/port][, ...]} and use the following syntax
and commands:
Figure 5-10
shows a sample of the config ethernet <ports> ip dvmrp info
command.
Passport-8610# config ethernet 9/3 ip dvmrp info
Sub-Context:
Current Context:
dvmrp : disable
metric : 1
Figure 5-10.
config ethernet ip dvmrp info
Command Output
show ports info dvmrp Command
The show ports info dvmrp command displays information about DVMRP
configuration for the specified port or for all ports.
This command uses the format:
show ports info dvmrp [<ports>]
config ethernet <ports> ip dvmrp
followed by:
info Displays DVMRP settings on the port.
enable Enables DVMRP on the port.
disable Disables DVMRP on the port.
metric <cost> Sets the DVMRP route metric.
• <cost> is the maximum number of hops with a
value of 1 to 31.
cli.book Page10 Wednesday, April 19,2000 3:14 PM