Filter
Top Products
Policies Commands
208967-B 7-17
show ip policy rip accept lists Command
The
show ip policy rip accept lists command displays the accept lists on
the switch. If an ID is entered, only that list is displayed.
This command uses the syntax:
show ip policy rip accept lists [id <value>]
Figure 7-14 is a sample.
Passport-8610# show ip policy rip accept lists
================================================================================
Policy Rip Accept List
================================================================================
ID EXACTNETLIST RANGNETLIST INJCTNETLIST RIPGATEWAY RIPINTERFACE
--------------------------------------------------------------------------------
4003 0 0 0 0 0
Figure 7-14.
show ip policy rip accept lists
Command Output
show ip policy rip accept match network Command
The
show ip policy rip accept match network command lists the policies
that match the specified network with a range or exact match.
This command uses the following format, where
<value> is the network address
{a.b.c.d/x | a.b.c.d/x.x.x.x | default}:
show ip policy rip accept match network <value>
Figure 7-15 is a sample.
Passport-8606# show ip policy rip accept match network 4.1.1.5/255.0.0.0
================================================================================
Policy Rip Accept Match Network
===============================================================================
RipAccept Policy Ids: 4001
Figure 7-15.
show ip policy rip accept match network
Command Output
cli.book Page17 Wednesday, April 19,2000 3:14 PM