Filter
Top Products
RIP and OSPF Commands
208967-B 3-31
Figure 3-25 is a sample display.
Passport-8610# show ports stats ospf main
================================================================================
Port Stats Ospf
================================================================================
PORT_NUM RX_HELLO TX_HELLO RXDB_DESCR TXDB_DESCR RXLS_UPDATE TXLS_UPDATE
--------------------------------------------------------------------------------
9/200000 0
9/300000 0
Figure 3-25.
show ports stats ospf main
Command Output
show ports stats ospf extended Command
The
show ports stats ospf extended command displays extended OSPF
information about the specified port or for all ports.
The command uses the syntax:
show ports stats interface extended [<ports>]
config vlan <vid> ip ospf Commands
The config vlan <vid> ip ospf commands set OSPF parameters for the
specified VLAN (
<vid> is 1 to 4094).
The commands use the following syntax and parameters:
config vlan <vid> ip ospf
followed by:
info Displays OSPF characteristics on the VLAN.
advertise-when-down
<enable|disable>
If enabled, the network on this interface is advertised
as up, even if no ports in the VLAN are active. The
default is disabled. Note: When you create a VLAN
with no active ports and enable advertise-when- down,
the route is not advertised until a port is active. Then
the route is advertised even when the link is down. To
disable advertising based on link status, disable this
parameter.
area <ipaddr> Sets the OSPF interface area ID for the VLAN.
cli.book Page31 Wednesday, April 19,2000 3:14 PM