Filter
Top Products
Reference for the Passport 8000 Series Command Line Interface Routing Operations
1-6 208967-B
Figure 1-6 is an example.
Passport-8610# show ip static-route info
================================================================================
Ip Static Route
================================================================================
DEST MASK NEXT COST PREFERENCE STATUS ENABLE
--------------------------------------------------------------------------------
0.0.0.0 0.0.0.0 10.10.40.1 1 0 ACTIVE TRUE
Total 1
Figure 1-6.
show ip static-route info
Command Output
config ethernet <ports> ip Commands
These commands are the more generic port-related IP routing commands. Other
port commands are included in the section dealing with the protocol or feature
(for example, DHCP).
In order for the
config ethernet <ports> ip commands to take effect, IP
forwarding must be enabled on the switch; by default on the Passport 8000 Series
switch, forwarding is enabled.
The command uses the syntax:
config ip forwarding enable
The port commands require the parameter <ports> as the port or list of ports on
which you are running the command {slot/port[-slot/port][, ...]}.
cli.book Page6 Wednesday,April19, 2000 3:14PM