Filter
Top Products
Reference for the Passport 8000 Series Command Line Interface Routing Operations
7-6 208967-B
config ip policy ospf announce Commands
The
config ip policy ospf announce commands allow you to configure the
OSPF announce policy, where the OSPF announce policy ID <pid> is in the range
2001 to 3000.
The commands use the following syntax and parameters:
config ip policy ospf announce <pid>
followed by:
info Displays the settings for the OSPF announce policy.
action <accept|ignore> Selects whether the OSPF policy action will be to
accept or ignore external route information.
add-route-source
<direct|static|rip|any>
Adds a route source to the announce policy; sets
direct, static, RIP, or any as accepted sources from
which the route can be learned.
advertise-netlist
<netlist id>
If the action is set to announce, allows sending or
advertising networks that differ from the actual
network in the routing table.
• <netlist id> is the netlist id range 0 to 1000
and allows advertisement of an aggregate or
default along with the actual network.
create Creates an OSPF announce policy.
delete Deletes an OSPF announce policy.
disable Disables an OSPF announce policy.
enable Enables an OSPF announce policy.
exact-netlist
<netlist id>
Sets an OSPF announce policy in which networks
will only match the specific network advertisement.
• <netlist id> is the netlist id range 0 to 1000.
ext-metric <ext-metric> Sets the OSPF announce external metric (0 to
65535).
ext-metric-type
<type1|type2>
Sets the OSPF announce policy external metric type
totype1ortype2.
name <string> Assigns the OSPF announce policy name.
precedence <precedence> Sets the precedence for the OSPF announce policy.
The range is 0 to 65535. If multiple policies apply, the
higher precedence is used.
range-netlist
<netlist id>
Sets the OSPF announce policy to match any
network number that falls into the indicated range.
• <netlist id> is the netlist id range 0 to 1000.
cli.book Page6 Wednesday,April19, 2000 3:14PM