Filter
Top Products
Reference for the Passport 8000 Series Command Line Interface Routing Operations
3-8 208967-B
config vlan <vid> ip rip Commands
The config vlan <vid> ip rip commands allow you to set RIP parameters for
a VLAN, where <vid> is the VLAN ID (1 to 4094).
These commands have the following syntax and parameters:
config vlan <vid> ip rip
followed by:
info Displays RIP characteristics on the VLAN.
advertise-when-down
<enable|disable>
If enabled, the network on this interface will be
advertised as up, even if the port is down. The
default is disabled.
Note: When you configure a port without any link
and enable advertise-when-down, it will not
advertise your route until the port is active. Then
the route is advertised even when the link is down.
To disable advertising based on link status, this
parameter should be disabled.
auto-aggr <enable|disable> Enables or disables automatic route aggregation
on the VLAN. When enabled, the router switch
automatically aggregates routes to their natural
mask when they are advertised on an interface in
a different class network. The default is disable.
default-listen
<enable|disable>
AllowstheusertoenableordisablesettingRIP
listen to accept the default route via RIP.
default-supply
<enable|disable>
Allows the user to send a default route only if one
exists in the routing table.
disable Disables RIP on the VLAN. This is the default
setting.
enable Enables RIP on the VLAN.
listen <enable|disable> Configures whether or not the switch will listen for
RIP routes.
manualtrigger Allows you to manually issue RIP updates.
cli.book Page8 Wednesday,April19, 2000 3:14PM